Initial effect filter cleaning method

In order to ensure the use effect, it is necessary to clean the initial effect filter regularly. The following is to talk about the cleaning way of the initial effect filter.

-. Open the suction grille in the device, press and hold the buttons on both sides and gently pull down.

2. Drag the hook on the air filter to pull out the equipment.

Three, with a similar vacuum cleaner equipment to remove the dust, or clean with warm water.

Four, if the dust is too much, you can use a soft brush and neutral detergent to clean. After cleaning, shake the water dry and leave to dry in a cool place.

Five, do not use hot water above 50° C to clean, so as to avoid fading or deformation of the equipment, and do not dry on the fire.

6. After cleaning, the equipment shall be installed in time. For installation, hang the device on the raised part of the upper part of the suction grille, then fix it on the suction grille and slowly slide the convex handle on the back of the suction grille inward until the whole device is pushed into the grille.

Seven, the last step is to close the suction grate, which is the opposite of the first step. Press the filter signal reset button on the control panel and the cleaning reminder will disappear.

Note: If the primary effect filter has too much dust in the use environment, the cleaning frequency should be increased according to the situation, generally once every six months. (The content is for reference only, if you have any questions or problems, please contact us online or call us. We will serve you wholeheartedly.)